Archivo del Autor: carlosap

You can install and run SDM on a router that is already in use without disrupting network traffic, but you must ensure that a few configuration settings are present in the router configuration file. Access the CLI using Telnet or the console connection to modify the existing configuration before installing SDM on your router. Step… Leer más »

0x2102 The default -> looks for a startup-config file in the NVRAM and for a valid IOS image in flash 0x2142 NVRAM contents are bypassed, startup configuration is ignored. 0x2100Router boots into ROM Monitor mode

Downloading and Installing Cisco Router and Security Device Manager

When would you need this: The upgrade is required when you plan to add more duties to the router or new hardware. The installation is required when the IOS image you have on the router is corrupted. Special Requirements: The router’s flash size should be enough for the new IOS image.

R1(config)# GLOBAL CONFIGURATION MODE R1_1841(config)#line vty 0 4 R1_1841(config-line)# exit takes back one level ^Z takes back to the privileged mode

up arrow = <CTRL-P> shows last command down arrow = <CTRL-N> brings one command up <CTRL-A>  takes the cursor all the way to the front of your current command <CTRL-E> takes the cursor all the way to the end of your current command left arrow = <CTRL-B> move backward character right arrow = <CTRL-F> move forward character Backspace… Leer más »

Configuring logging synchronous command on the console port to hold messages until detects no input from the keyboard. R1_1841(config)#line con 0 R1_1841(config-line)#logging synchronous exec timeout: R1_1841(config-line)#exec-timeout ? Timeout in minutes #####For educationals purposes###### R1_1841(config-line)#exec-timeout 0 0 R1_1841(config-line)#end ###Default time exec is 5 minutoes##### R1_1841(config-line)#exec-timeout 5 0 R1_1841(config-line)#end

R1_1841(config)#banner ? LINE c banner-text c, where ‘c’ is a delimiting character exec Set EXEC process creation banner incoming Set incoming terminal line banner login Set login banner motd Set Message of the Day banner prompt-timeout Set Message for login authentication timeout slip-ppp Set Message for SLIP/PPP R1(config)#banner motd $ Mantenimiento al router $ R1(config)#banner… Leer más »

sw_usuarios(config)#interface ? Async Async interface BVI Bridge-Group Virtual Interface CTunnel CTunnel interface Dialer Dialer interface Filter Filter interface Filtergroup Filter Group interface GigabitEthernet GigabitEthernet IEEE 802.3z Group-Async Async Group interface Lex Lex interface Loopback Loopback interface Null Null interface Port-channel Ethernet Channel of interfaces Portgroup Portgroup interface Pos-channel POS Channel of interfaces Tunnel Tunnel interface… Leer más »