Archivo del Autor: carlosap

enable password:switch>enswitch#conf t switch(config)#enable secret cisco Protect COM portswitch>enswitch#conf t switch(config)#line console 0password ciscologin ( needs login to ask the password for the COM port) renember copy the running-config to startup-config COM password line con 0    password cisco login    Telnet passwordline vty 0 4 password cisco login    line vty 5 15 password cisco login    ———————————————-To encrypt passwords———————————————- switch(config)#service password-encryption line con 0 password 7 DGASDFSDFSFD loginline… Leer más »

Switch>enableSwitch#configure terminalSwitch(config)#hostname switchPedritoswitchPedrito(config)#switchPedrito(config)#interface vlan 1 switchPedrito(config-if)#ip address 192.168.1.253 255.255.255.0 ?secondary Make this IP address a secondary addres<cr> switchPedrito(config-if)#ip address 192.168.1.253 255.255.255.0switchPedrito(config-if)#endswitchPedrito(config)# switchPedrito#show interfaces vlan 1 Vlan1 is administratively down, line protocol is down  Hardware is EtherSVI, address is 001d.e6e1.8e40 (bia 001d.e6e1.8e40)  Internet address is 192.168.1.253/24  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,     reliability… Leer más »

  SYSTEM Green good ( amber bad)RPS ( Redundant Power Supply)Stat ( Status of the port ) Util ( Utilization: show the current utilization of the switch )Duplex ( Duplex: Working in full duplex mode ) Speed ( Speed: 100mb or 1000mb )  

clock set 13:16:30 march 02 2008 Switch> User Mode (user exec)Switch# Priviliged Mode ( Priviliged Exec)Switch(config)# Global Configuration Mode to go to Priviliged Mode:Switch> enableSwitch# Global Configuration Mode:Switch#configure terminalSwitch(config)#hostname carlos_switch show history Navigation:ctrl a move the cursor to the start of the linectrl e move the cursor to the end of the line  

HyperTermTeraTermMiniCOMSecureCRTPutty Set It to Connect via COM port with: Baud Rate: 9600Data Bits: 8Parity: NoneStop Bits: 1Flow Control: None