Archivo del Autor: carlosap

WHAT ARE THE «AZIMUTH AND ELEVATION» OF A SATELLITE?

Azimuth and Elevation are measures used to identify the position of a satellite flying overhead. Azimuth tells you what direction to face and Elevation tells you how high up in the sky to look. Both are measured in degrees. Azimuth varies from 0° to 360°. It starts with North at 0°. As you turn to… Leer más »

baby steps goes

Antena de Directv: https://climaflorida.net/goes-r.htm?fbclid=IwAR3ENT3hJON9Uxw65yS8yWGKD1Nm3BVwWgPoyknWNfe9mcVQ7Qs5nsqTxe0 https://hackaday.io/project/161400-rtl-sdr-to-acquire-data-from-goes-16-satellite Receive GOES-16 and GOES-17 Images with a Raspberry Pi and RTL-SDR dongle https://gist.github.com/lxe/c1756ca659c3b78414149a3ea723eae2?fbclid=IwAR0w2cDWsaZ2HvyYcLHfJniRCrETMC24qDG2hr6PosGiKkT-t7krMYx2Mls

Categoría: SDR

yagi antenna

https://www.changpuak.ch/electronics/yagi_uda_antenna_DL6WU.php

Categoría: SDR

Perseids shower using graves radar

source: http://www.eb3frn.net/?p=141 he past agoust I was build a passive radar to detect the Perseids meteor shwoer . The most easy way is locate a very away transmiter and try to se the echoes produces by the meteors ionizacion. Perseids meteor Graves radar To do the detector I used a rtlsdr receiver tuned to the Graves radar at 143.050 MHz, a… Leer más »

Categoría: SDR

Signal Identification Guide

https://www.sigidwiki.com/wiki/Signal_Identification_Guide?fbclid=IwAR015sz-OpCF4rgR1jaTU3rWPLgUBNlluq1u9sHrrvdtkduzZVXd5wtCzFI

Categoría: SDR

radio frequency transmitter for Raspberry Pi – rpitx

rpitx is a general radio frequency transmitter for Raspberry Pi which doesn’t require any other hardware unless filter to avoid intererence. It can handle frequencies from 5 KHz up to 1500 MHz. Rpitx is a software made for educational on RF system. It has not been tested for compliance with regulations governing transmission of radio signals.… Leer más »

Categoría: SDR